Annular Hole Cutter Tct 18 X 35mm Weld Shank 19.05mm

PACK SIZE

The price displayed for this product is the unit price of the product. Where a PACK SIZE is indicated, this refers to the recommended ordering quantity and is also indicative of how many of these products are packaged in a box.

Stock: 51
Model: TCAC018-3
UPC: 6009515895068

Price:

R 777.61

Ex VAT: R 676.18

Available Options

Stockist

Tork Craft Annular Hole Cutter — TCT 18 × 35 mm, 19.05 mm (3/4") Weldon

Size: 18 mm x 35 mm [3/4" Weldon Shank]

The Tork Craft 18 mm TCT annular cutter is built for speed and durability when drilling through tough materials. Tungsten-carbide tips stay sharp longer, while the thin-wall design removes only a ring of material for faster cuts, less feed pressure, and minimal burrs. Perfect for mag-base drills on site or in the workshop when you need repeatable, precision holes.

Extra Information

Use in magnetic-base drills or compatible arbors in drill presses.
Requires a pilot pin for centering and slug ejection (sold separately).
For best results on stainless and harder grades, apply suitable cutting fluid and moderate feed.

Pro Tip

Engage the hole cutter on a clean, flat surface, start at low speed, and apply steady feed. Use cutting fluid to extend tool life and improve surface finish.

Features

18 mm diameter — accurate holes for bolts, fittings and conduit.
35 mm cutting depth — covers common plate and structural sections.
19.05 mm (3/4") Weldon shank — secure two-flat drive for most magnetic drills.
TCT (tungsten-carbide-tipped) teeth — long life in abrasive and hard materials, including stainless.
Thin-wall, multi-flute body — fast penetration with efficient chip evacuation.

Benefits

Drills faster than twist bits by removing less material.
Cleaner holes with reduced burrs and better finish, saving post-processing time.
Long service life thanks to wear-resistant carbide tips.
Less effort — lower feed pressure needed on vertical and overhead work.

Safety

Wear eye, ear and gloves protection; use cutting fluid to control heat.
Ensure magnet adhesion is secure before drilling; tether the drill when working at height.
Do not use hammer action; maintain steady, straight feed and allow the slug to eject.
Disconnect power before changing cutters or pilot pins.

Specifications

Description	Spec
Brand	Tork Craft
Cat No.	TCAC018-3
Product Type	Annular hole cutter (TCT)
Diameter	18 mm
Cutting Depth	35 mm
Shank	19.05 mm (3/4") Weldon, two-flat
Tip Material	Tungsten-carbide-tipped
Suitable Materials	Mild & structural steel, stainless (with coolant), cast iron
Recommended Machine	Magnetic-base drill / drill press with suitable arbor
Pilot Pin	Required for centering & slug ejection (size depends on arbor)
Pack Quantity	1