Professional Spray Gun Suction Cup 1.4mm Nozzle Hvlp
Professional Spray Gun Suction Cup 1.4mm Nozzle Hvlp
Price:
R 918.85
Ex VAT: R 799.00
Tips and techniques
When sprayfinishing, it's always advised to keep the spray gun parallel to the workpiece surface. The distance from the surface of the workpiece should be the width of the spray pattern.
The lower the pressure of the air, the lower the chance to have bounce-back (overspray). The pressure should only be increased when the spray pattern is uneven - paint focused in the middle when the fan setting is wide.
Extra Information
- Use clean, dry, filtered air (water trap and regulator) to maintain consistent atomisation and finish quality.
- Strain your coating before filling the cup to reduce blockages and improve spray consistency.
- Match viscosity to your nozzle size and settings—thin and test on a sample surface before the main job.
- Clean the gun thoroughly after use to prevent dried material from affecting performance.
Pro Tip
- Start with the fan wide, then dial fluid in gradually until the pattern is even and wet without runs. A quick test spray on cardboard can save an entire project from orange peel and dry spray.
AirCraft Nozzle Kit 1.7mm For SG-MP200 Spray Gun (SG-MP200-01)
At a Glance: 1.7mm replacement nozzle kit for high-flow spraying and dependable cove..
R 495.42
Ex VAT:R 430.80
